|本期目录/Table of Contents|

[1]杨 帆,张辉寰.无线楼宇安全监测系统的设计[J].武汉工程大学学报,2018,40(03):310-314.[doi:10. 3969/j. issn. 1674?2869. 2018. 03. 016]
点击复制

无线楼宇安全监测系统的设计(/HTML)
分享到:

《武汉工程大学学报》[ISSN:1674-2869/CN:42-1779/TQ]

卷:
40
期数:
2018年03期
页码:
310-314
栏目:
机电与信息工程
出版日期:
2018-06-26

文章信息/Info

Title:
Design of Wireless Building Safety Monitoring System
文章编号:
20180316
作者:
杨 帆12张辉寰1
1. 武汉工程大学电气信息学院,武汉 4302052. 湖北省视频图像与高清投影工程技术研究中心,武汉 430205
Author(s):
-

YANG Fan1,2, ZHANG Huihuan1
关键词:
CC2530 楼宇监测 无线传感节点 远程控制
Keywords:
CC2530 building monitoring wireless sensor node remote control
分类号:
TP29
DOI:
10. 3969/j. issn. 1674?2869. 2018. 03. 016
文献标志码:
A
摘要:
针对楼宇安全监测系统使用范围不够大和使用器件过多,导致成本过高和组网不灵活等缺陷,研究并设计了一套无线网络传输系统以及对应的Z-Stack协议栈。系统主要由传感器模块、路由节点模块与协调器模块以及上位机组成,使用了CC2530芯片作为各个模块传感通讯的核心元件,并且用来有效的控制这三个模块。由于CC2530自带通信元件的使用范围有限,所以在此模块扩充一个CC2591芯片增加了系统的使用范围。设计的系统实现了节点接收和发送信息,并且在上位机PC机界面可以观察到每个传感器和路由的实时动态情况并且能远程控制,当节点故障时上位机及时的显示报警,并且在故障节点处发出警报提示周围的人员。
Abstract:
The current monitoring system of building safety has some defects, such as limited applications and too many devices which result in high cost and inflexible network. To solve this problem, a wireless network transmission system and its corresponding protocol for Z-Stack were designed. The system is mainly consisted by four parts: a sensor module, a routing node module, a coordinating module and an upper computer module. A CC2530 chip was used as the core-controlling element of wireless sensor communication to effectively control three modules. Because the communication ability of CC2530 component was limited, then the other CC2591 chip was added to this module to expand the application of the system. The designed system realized the functions of receiving and sending data. The real-time dynamic situation of each sensor and routing could be observed and controlled through the person-machine interface of upper computer. When the node failure?occurred, the upper computer would alarm in time to alert the people who were around the fault node.

参考文献/References:

1] 宫周鼎. 智能建筑设计与建设[M]. 北京:北京知识产权出版社,2001:1-6. [2] 刘强,崔莉,陈海明. 物联网关键技术与应用[J]. 计算机科学,2010,37(6):1-4. [3] 万文青,赖松林. 基于ZigBee 的楼宇安防报警系统的设计与实现[J]. 电子测量技术,2012,35(12): 117- 120. [4] 钟永峰,刘永俊. Zigbee无线传感网络[M]. 北京:北京邮电大学出版社,2011:3-22. [5] 杨帆,向延红,郑纯典,等. 楼宇末级配电设备群的控制器设计[J]. 华中科技大学学报(自然科学版),2017,45(6):43-47. [6] 赵文静,秦会斌,吴建锋,等. 基于 ZigBee技术的智能楼宇环境监测系统的设计[J]. 机电工程, 2010, 27(8):114-117. [7] 许铭霖,林伟,蔡钧涛. 基于Zigbee的楼宇照明控制系统的设计[J]. 计算机技术与发展,2006,16(5):341-343. [8] 周武斌. Zigbee无线组网技术的研究[D]. 长沙:中南大学,2009. [9]  王彤. 基于Z-Stack协议栈的ZigBee网络组网研究与实现[D]. 保定:河北大学,2012. [10] TERADA M. Application of ZigBee sensor network to data acquisition and monitoring[J]. Measurement Science Review,2009,9(6):183-186. [11] ZHANG X, WU H L,MARCIN U. Usefulness of nonlinear interpolation and particle filter in Zigbee indoor positioning[J]. Geodesy and Cartography,2014,63(2):219-233. [12] JANICKA J,RAPINSKI J. An Example and analysis for ambiguity resolution in the indoor ZigBee positioning system[J]. Reports on Geodesy and Geoinformatics,2017,103(1):1-9. [13] HIRAGURI T, AOYAGI M,MORINO Y. Proposal of ZigBee systems for the provision of location information and transmission of sensor data in medical welfare[J]. E-Health Telecommunication Systems and Networks,2015,4(3):45-55. [14] 赫晓星. ZigBee路由协议分析与改进[D]. 武汉:华中师范大学,2011. [15] MEDGLI P,FERRARI G,MARASITONE M. Hybrid Zigbee-RFID networks for energy saving and lifetime maximization[M]. New York:Springer,2010:473-491.

相似文献/References:

备注/Memo

备注/Memo:

收稿日期:2017-01-26基金项目:国家自然科学基金(51541709);武汉工程大学研究生教育创新基金(CX2016060)作者简介:杨帆,硕士,教授。 E-mail:[email protected]引文格式:杨帆,张辉寰. 无线楼宇安全监测系统的设计[J]. 武汉工程大学学报,2018,40(3):310-314.
更新日期/Last Update: 2018-06-28